18
WIRING INSTRUCTIONS FOR
ACCESSORIES
•
Place entrapment warning label on the inside of
door as a reminder of safe operating procedures.
Place the manual release/safety reverse test
label in plain view on the inside of the garage
door.
To prevent possible SERIOUS INJURY or DEATH from
electrocution:
• Be sure power is not connected BEFORE installing door
control.
To prevent possible SERIOUS INJURY or DEATH from a
closing garage door:
• Install door control within sight of garage door, out of reach of
children at a minimum height of 1.5m, and away from all
moving parts of door.
• NEVER permit children to operate or play with door control
push buttons or remote control transmitters.
• Activate door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep garage door in sight until completely closed.
NEVER permit anyone to cross path of closing garage door.
WARNING
CAUTION
WARNING
WARNING
WARNING
KEY SWITCH MODEL 059009
To opener terminal: white to 2; white/red to 1.
SAFETY INFRA-RED REVERSING SENSOR
MODEL 062153
To opener terminal screws: white to 2; Black to 3.
DOOR CONTROL PANEL 062159
To opener terminal: white to 2; white/red to 1.
INSTALLATION STEP 7
Install the Light
• Press the release tabs on both sides of lens. Gently
rotate lens back and downward until the lens hinge
is in the fully open position. Do not remove the
lens. Install a 40 watt maximum (socket size E27),
light globe in the socket as shown.
• The light will turn on and remain lit for 2-1/2
minutes when power is connected. After 2-1/2
minutes it will turn off.
• Reverse the procedure to close the lens.
Replace burned out globes with rough service
light globes.
Release tabs
of lens
40W Max
Light Bulb
Socket
