SECTION 4 – FITTING ACCESSORY ITEM
Wired Accessories
A variety of accessory items can be fitted to the opener (eg Safety Infra Red Beam
or a wall switch). In order to connect any accessory a standard Plug-in 8A 5.08mm
Pitch x 5 PCB Mounting Terminal Block will need to be fitted to the outlet of the
Printed Circuit Board. To install this connector you will need to remove the light
cover and using a suitable tool, remove the breakout on the cover to allow the
wiring to pass through to the opener.
This connector is available from B&D as follows:
Part No 59689
Terminal Connector Qty 1
Part No 59690
Terminal Connector Qty 10
Once the plug has been fitted, wiring of accessory items is as follows:
PIN
NAME
DESCRIPTION
1
Ground (-Ve)
Common ground terminal (-Ve) used by all accessories
2
Safety IR Beam
To connect the Safety Infra Red Beam (Part No 62153) sensors:
Connect both white wires to Pin No 1 (Ground terminal).
Connect both white with black stripe wires to Pin No 2.
The nominal output voltage is 5.5V with a capacity of 50mA before
shutdown to Low Power mode.
3
Power (+Ve)
Power output for external receiver or other powered accessory - Voltage
12-17 VDC.
Maximum continuous current capacity 100mA.
This output is protected against short circuit by a 200mA polyfuse.
4
Door Travel
A normally open, momentary push button can be connected between
Limit Setting
this terminal and Ground (Pin No 1) to provide a remote Limit Set switch
as an alternative to the limit setting described in Step 7.
5
Remote Operate
A normally open, momentary push button can be connected between
this terminal and Ground (Pin No 1) to provide a remote Operate switch.
This switch may be illuminated with an LED as this pin has an integral
560 ohm pull-up to +Ve (i.e. 19mA @ 1.5v).
Note:
Any pin may be shorted to any other pin or ground without damaging the opener.
Whilst the short circuit exists the opener will fail to operate. This feature protects against damage caused by shorts
in external accessory wiring.
When installing Accessories, always follow the manufacturer’s instructions included
with the product.
Page 14
©Copyright 2001
B&D Australia
5 4 3 2 1
