19
INSTALLATION STEP 7
Install the Light Globe and Lens
INSTALL THE LIGHT GLOBE
• Install a rough service 40 watt maximum light
globe in the socket as shown. The light will turn on
and remain lit for 4-1/2 minutes when power is
connected. After 4-1/2 minutes it will turn off.
• Apply slight pressure on sides of the light cover
and slide tabs into slots in the end panel. Reverse
the procedure to remove the light cover.
• Replace burned out globes with rough
service/heavy duty light globes.
INSTALLATION STEP 8
Attach the Emergency Release
Rope and Handle
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot at
least 25mm from the end of the rope to prevent
slipping.
• Thread the other end of the rope through the hole
in the release arm of the outer trolley.
• Adjust rope length so the handle is 1.8m above
the floor. Secure with an overhand knot.
If it is necessary to cut the rope, heat seal the cut
end with a match or lighter to prevent unraveling.
Trolley
NOTICE
Overhand
Knot
Emergency
Release Handle
Rope
Trolley
Release Arm
• To prevent possible SERIOUS INJURY or DEATH from
a falling garage door:
– If possible, use emergency release handle to
disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
– NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If rope
knot becomes untied, you could fall.
WARNING
CAUTION
WARNING
WARNING
Lens Slot
40 Watt Max.
Light Globe
Lens Tab
Light Lens
114A2558F
