4
Documentation Number ETCIACT0698 Manual
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5105
Chapter 3: Configuration and Software Installation
This chapter assumes that you have already finished the hardware
installation step. If you have not completed this step go to Chapter 2:
Hardware Installation.
It is also assumed that when your Operating System was installed that
the Card Service support and the Socket Services support were included
with the Operating System installation. See section 3.2 for information on
installing Card Service and Socket Services support if your system does
not already have these installed.
The software installation will depend on your Operating System. If
you are installing the network adapter card in a PC with an Operating
System other than Windows 95, you can install the device driver from the
driver disk supplied with your adapter card. The drivers are organized on
the disk in separate subdirectories. For example, Windows for
Workgroups 3.10 is found at a:\wfw31 if you are using the “A” drive.
Each directory contains a text file to explain the installation of that
particular driver.
For Windows 95 do the following:
a) Boot to Windows.
b) Go to control panel (Start/Settings/Control Panel).
c) From Control Panel select Add Hardware.
d) Follow the directions in the dialog boxes.
e) If the Add Hardware wizard does not recognize the device you will see
this dialog box.
