2
INSTALLING THE ACCESS CONVERTER/3
Install the Access Converter/3 as a table-top device, or mount to a wall surface with
the appropriate bracket (included). To wall mount, use the supplied screws to
attach the wall-mount bracket to the Access Converter/3, then simply mount the
unit to the wall by tightening the screws (not supplied).
Note
The Access Converter/3 packaging also includes four small rubber “feet” for use in
table-top or wall-mount installations.
Plug the Access Converter/3 into a power source and attach the connected devices.
Verify installation by observing the LEDs on the unit (refer to the LED Operation
section for more information).
Wall Mount Bracket
Screw holes for mounting unit to the wall.
Wall-mount bracket must be attached
to the bottom of the unit.
Screw holes for mounting
wall-mount bracket with
supplied screws
3
LED OPERATION
Each Access Converter/3 includes diagnostic LEDs for troubleshooting.
Front
Back
Twisted Pair Downlink Ports
The LED indicator for the twisted pair downlink port is located on the RJ-45
connector of the downlink port next to the power connector. There are two LED
functions for the twisted pair downlink ports. LED functions are as follows:
•
Glows amber when a link is established on the copper port
•
Glows amber indicating a valid link, then blinks amber when activity is
detected on the copper port.
Note
The green LED on RJ-45 connectors are reserved for future use, with one
exception— refer to the following Uplink Port sections for more information.
Uplink LED
Fiber Uplink
LED
TX Downlink LED
