Documentation Number 3PCIOSD2x-3903 Manual
Chapter 2
5
B&B Electronics Mfg Co – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104
B&B Electronics Ltd – Westlink Comm. Pk. – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445
Chapter 2:
SETUP
Inspection
Your 3PCIOSD2x serial card was tested for proper operation before
shipment. It should be in perfect mechanical and electrical condition
upon receipt.
The card is normally pre-configured for RS-232 operation.
The data clock speed for both ports is set by one jumper to x1
(normal) operation or to x4 operation.
The operating mode of each port on the card is set using 8 jumpers,
4 jumpers select RS-232 operation or RS-422/485 operation, one
jumper sets RTS for RS-232 & RS-485 modes or Send Data for RS-
485 mode, 2 jumpers select RS-422 or RS-485 operating modes for
Receive and Transmit, and the last selects 120 ohm termination for
the RS-422 or RS-485 Receiver.
Refer to
Jumper Mode Table
in
Appendix C.
Before removing the card from the anti-static protective packaging:
Discharge any static electricity build-up on your body by
touching a large grounded metal surface or the metal chassis on
equipment connected to earth ground by a 3-wire power cord.
Avoid touching the gold connectors or other parts on the card
except as necessary to set the configuration jumpers for each
port. After setting the jumpers, ground yourself to the computer
chassis before and while inserting the card.
Remove AC power from the computer and unplug the power
cord before inserting the card.
Retain the ESD bag for handling the card.
Save the packaging for storage or shipping.
CAUTION:
ELECTROSTATIC SENSITIVE DEVICE
Use ESD precautions for safe handling.
