Bamix MX100906, Full Instruction Manual

Page: 48 / 190

47
Mounting and changing attachments
All attachments feature a recess (figure 1).
The drive shaft stub of the bamix
®
is equipped with a drive pin
(figure 2).
Push the attachment as straight as possible onto the stub so
that the drive pin engages in the recess on the attachment. Plea-
se make sure that the attachment is exactly parallel to the cutter
guard and properly aligned with the stub (figures 3/4).
To remove the attachment, just pull it from the stub. If the
attachment cannot be easily pulled off, loosen it by placing the
bamix
®
in hot dish-washing water and switching the appliance
on briefly. Disconnect the power plug from the socket and pull
off the attachment. If necessary, lever it off with a suitable im-
plement (e.g. screwdriver).
It is possible that, over time, the attachments will not fit as
firmly on the stub. In this case,
slightly press the spring bla-
des together with a pair of pliers.
Before changing the attachment, disconnect the
power plug of the appliance from the socket.
Do not touch rotating attachments.
Recess
Drive pin
Mount and remove attachment
vertically
Lock in place