baltur TBML 350 ME, Installation, Use And Maintenance Instruction Manual, Page: 58 / 92

ENGLISH
12 / 44
0006160077_201802
HINGE UNIT ASSEMBLY TO THE RIGHT OR LEFT
The burner hinge can be opened both ways, it is therefore possible to
reverse the opening side of the ventilating body.
As a standard, the burner is supplied with the hinge installed on the
left side.
To enable the maximum opening and so facilitate maintenance
operations, it is recommended to install the hinge on the side of the
burner opposite to the position where the gas train is installed.
In case it is necessary to install the hinge on the right side, proceed
as follows:
• Loosen the screws -15 retaining the two hinge halves -17 and refit
the lower hinge half on the right side.
• Position the hinge pin -10 on the burner boil aligned with the lower
half of the hinge -12, and insert it in the hole.
• Insert the upper half of the hinge -17 in the pin -10 and anchor it to
the sleeve with the screws and the washers -15 provided.
• After aligning the holes in the head unit with the ventilating body
with the screw and lock nut -16, screw in the screws with their
washers -15 to anchor the head unit onto the specific ventilating
body.