baltur TBG 1100 ME, Installation, Use And Maintenance Instruction Manual

Page: 40 / 56

ASSEMBLING THE GAS TRAIN
The EN 676 approved gas train is sold separately from the burner.
The gas train can be assembled in different ways: -11, -12
The gas train can be assembled in different ways -8, -9, -10, -11,
-12, of the gas train.
Choose the most rational position for the set-up of the boiler room
and the position in which the gas pipeline arrives.
GAS TRAIN PRINCIPLE DIAGRAM
DANGER / CAUTION
Install a manual on/off valve upstream of the gas valve ac-
cording to the layout shown in the diagram illustrating the
gas train principle.
• To ensure optimal operation of the pressure regulator, it should
be applied to the horizontal pipe after the filter.
• The gas pressure regulator must be adjusted when it is working
at the maximum output actually used by the burner.
• The outgoing pressure must be adjusted to a value slight-
ly below the maximum possible value (the value obtained by
screwing in the adjustment screw almost completely); in this
case, the outgoing regulator pressure increases as the adjust-
ment screw is tightened, and decreases as it is slackened.
GAS SUPPLY LINE
RESPONSIBILITY OF THE
INSTALLER
LIMITS ON BALTUR SUPPLY
1 Air regulation servomotor
2 Air pressure switch
3 Maximum gas pressure switch
4 Gas supply control butterfly valve
5 Operating gas valve with pressure regulator
6 Valve tightness control device (integrated in the apparatus)
7 Safety valve
8 Minimum gas pressure switch and gas leak control
9 Gas filter
10 Air vibration-proof joint (not supplied)
11 Manual shut-off valve (not supplied)
12 Gas regulation servomotor
ENGLISH
12 / 26
0006160027_201502