6)
If not already placed, install the personality chips U18 and U20 chips on the board. Remove the
"mains" U28 and U43 chips. Temporarily install the U28 and U43 Clear chips in their positions. Place
the board back into the machine. Press and continue to hold the "Test" and "Pseudo Coin" buttons on
the board and power on. Continue to hold until the buttons on the deck flash on and off continuously.
Let go of the buttons and power the machine off. Replace the original U28 and U43 mains back into the
machine.
7)
After the board is place back into the machine, insure that the small cable is installed at the
front left of the board. Power the machine back on leaving the door open. After it boots back up the
display on the reel glass will show a bunch of number with the far left one flashing. Press the "change /
attendant" button one time to clear. The display should go to "50". Press the test button on the board
continuously until the display reads "11d". Once you see 11d, stop pressing the button. The display will
change to 27 on the left and 001 on the right.
You must now go through the parameter and change the settings for each. The number on the left is
the parameter and on the right is its current option setting. Read carefully....to cycle to the next
parameter press the Bet Max button. To change the current setting on the parameter you are looking at
press the Spin button. Most settings you will not change....and leave as the default, only change the
ones listed below. Cycle to each parameter listed below and change from the default setting to the new
one listed.
If you have coin mechanics:
Parameter
Setting
9
4
2
4
7
1
56
160
78lo
1
51
5000
58
1000
