Balluff BVS ID-M1280-F1 Series, Configuration Manual

Page: 182 / 342

BVS ID-M1280xF1-xx-xxx
8 english
•
•
•
•
•
1.
2.
3.
2 SensorApp / Webinterface
2.1 Introduction
Normally, the BVS ID is configured via Auto Setup process. However, the operator has the possibility to adjust
the configuration via the web interface ("SensorApp").
to adjust the sensor configuration,
display live images,
view statistics and
Change system settings.
View device states and errors.
Perform the following actions:
Open a web browser.
Enter the following URL:
http://192.168.10.2 .
Confirm the entry.
Depending on the network topology, different network settings are required. Usually, in a company network or in
a production facility, the IP addresses are fixed. In case of connection difficulties, please consult your network
administrator.
2.1.1 The SensorApp interface
Number Name Meaning
1 System menu For adapting system relevant settings like network behavior, communication,
etc.
2 Action menu For configuring and monitoring the inspection
3 Result table For showing the inspection results
4 Live image Showing the live image
5 Device info Showing device information, states and errors
By default, the IP address of the BVS ID is set to 192.168.10.2. However, you can change this to
DHCP in the system settings.
NOTE
