196
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Micro PDF417
Length Control
This feature specifies either variable length decoding or fixed length decoding for this symbology.
Variable Length:
For variable length decoding, a minimum and maximum length may be set.
Fixed Length:
For fixed length decoding, two different lengths may be set.
Micro PDF417 Set Length 1
Specifies one of the barcode lengths for
Micro PDF417 Length Control on page 196
. Length 1 is
the minimum label length if in
Variable Length
Mode, or the first fixed length if in Fixed Length
Mode. Length includes the barcode’s data characters only. Characters can be set from 0001 to
0366 characters (pad with zeroes) in increments of 01. Any value greater than 0366 will be con-
sidered to be 0366.
See
for detailed instructions on setting this feature.
Micro PDF417 Length Control =
Variable Length
Micro PDF417 Length Control = Fixed Length
Select Micro PDF417 Length 1 Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix 18, Use the barcodes in this
appendix to enter numbers as you would
select digits/characters from a keypad.
rep-
resenting your desired character(s). End by
reading the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
DEFAULT
MILC00(CR)
CMILC01(CR)
$CMIL1
~
DEFAULT
0001 = Length 1 is 1 Character