Balluff BVS HS-Q Series, Operation Manual

Page: 228 / 296

228
BVS HS-Q Series
Standard Hand Held Barcode Reader
5
References
ACK NAK
Timeout Value This option specifies the amount of time the reader waits for an ACK character from the host fol-
lowing label transmission. The selectable timeout range is 200 milliseconds to 15,000ms (15 sec-
onds) in 200ms increments. A selection of 0 disables the timeout.
To set this value:
1 Determine the desired setting in milliseconds.
2 Divide the desired setting by 200 (setting is in 200ms increments). Pad the result with leading
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3 Go to page 41 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
4 Scan the barcode: SELECT ACK NAK TIMEOUT VALUE SETTING.
5 Scan the appropriate two digits from the keypad in Appendix 18, Use the barcodes in this
appendix to enter numbers as you would select digits/characters from a keypad. , that repre-
sent the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
6 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See Table ACK NAK Timeout Value Setting Examples for some
examples of how to set this feature.
ACK NAK
Timeout Value
Setting
Examples
If you make a mistake before the last character, scan the CANCEL barcode
to abort and not save the entry string. You can then start again at the begin-
ning.
STEP ACTION EXAMPLES
1 Desired Setting 200ms
1,000ms
(1 sec.)
5200ms
(5.2 sec.)
15,000ms
(15 sec.)
2 Divide by 200 01 05 26 75
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT ACK NAK TIMEOUT VALUE SETTING
5
Scan Two Characters
From
Appendix 18, Use
the barcodes in this
appendix to enter
numbers as you would
select digits/characters
from a keypad.
‘0’ and ‘1’ ‘0’ and ‘5’ ‘2’ and ‘6’ ‘7’ and ‘5’
6 Scan ENTER/EXIT PROGRAMMING MODE