Balluff BVS HS-P Series, Operation Manual

Page: 248 / 314

248
4
References
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
4.2.3 Intercode Delay Specifies the delay between labels transmitted to the host for this interface. The selectable range
for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1 Determine the desired setting.
2 Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20,
etc
3 Go to page 50 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
4 Scan the barcode: SELECT INTERCODE DELAY SETTING.
5 Scan the appropriate two digits from the keypad in Appendix D: Keypad , that represent the
duration which was determined in the steps above. You will hear a two-beep indication after
the last character.
6 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See Table Wedge Intercode Delay Examples for some examples
of how to set this feature.
Wedge
Intercode Delay
Examples
NOTE
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
STEP ACTION EXAMPLES
1 Desired Setting No Delay 5 Seconds 60 Seconds 99 Seconds
2
Pad with leading
zero(es)
00 05 60 99
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCODE DELAY SETTING
5
Scan Two Characters
From
Appendix D:
Keypad
‘0’ and ‘0’ ‘0’ and ‘5’ ‘6’ and ‘0’ ‘9’ AND ‘9’
6 Scan ENTER/EXIT PROGRAMMING MODE