Balluff BIS V-6106, Technical Reference, Operating Manual

Page: 125 / 494

www.balluff.com
BIS V-6106 Ethernet/IP™
Processor Unit
25 english
Two buffers are needed to exchange data and commands between the processor unit and the
host control system (input buffer and output buffer). The buffer contents are exchanged using
cyclical polling. The buffer content depends on the cycle in which it is written (for example,
control commands at the beginning of a job).
When writing to the buffer, the transmitted data from the previous cycle is overwritten. Unwritten
bytes are not deleted and retain their data content.
Process data input (Assembly 100, T->0)
Instance 100
Data length 308
Bytes 0…63 RFID head 1, 64 bytes
Bytes 64…127 RFID head 2, 64 bytes
Bytes 128…191 RFID head 3, 64 bytes
Bytes 192…255 RFID head 4, 64 bytes
Byte 256 Pin 4 input data (if port was not configured as IO-Link)
Byte 257 Short circuit status
Byte 258 Overload status (only if port was not configured as standard I/O)
Byte 259 Power status:
Bit 0 = No actuator supply
Bit 1 = Sensor power
Bit 2 = Actuator power
Bytes 260…291 IO-Link process data, 32 bytes
Byte 292 IO-Link status
Byte 293 IO-Link error
Bytes 294…295 IO-Link vendor ID, 2 bytes
Bytes 296…298 IO-Link device ID, 3 bytes
Bytes 299…307 IO-Link 3 events for every 3 bytes
Process data output (Assembly 101, 0->T)
Instance 101
Data length 292
Bytes 0…63 RFID head 1, 64 bytes
Bytes 64…127 RFID head 2, 64 bytes
Bytes 128…191 RFID head 3, 64 bytes
Bytes 192…255 RFID head 4, 64 bytes
Byte 257 IO-Link pin 4 restart output after short circuit
Byte 258 Reserved
Byte 259 IO-Link control:
Bit 0 = Red LED on display on
Bit 1 = Green LED on display on
Bit 2 = Display lock/PLC lock
Bytes 260…291 IO-Link process data, 32 bytes
7.1 Function
Principle of the
BIS V-6106
7
Device Functions