–
The device may be installed, connected and put into service only
by a person trained in safety technology and electronics.
–
The relevant technical standards must be considered as part
of the respective application.
–
Observe the requirements of EN 60204 when installing.
–
If the device malfunctions, contact the manufacturer.
Opening of and tampering with the device are not permitted.
–
Disconnect the device from power before working on it.
If appropriate also turn off independently powered relay circuits.
–
Perform a complete function test after installation, maintenance
or repair.
–
Use the device only in specified ambient conditions (see
Section 8 Maintenance, Care, and Disposal on page 30).
Contact the manufacturer for any special ambient conditions.
–
Use only within the specified application description.
–
Safety requirements for the application
–
The safety requirements for the respective application must agree
with the requirements laid out here.
www.balluff.com
15
BES M…-D11 Inductive Safety Sensors
Courtesy
of
CMA/Flodyne/Hydradyne
▪
Motion
Control
▪
Hydraulic
▪
Pneumatic
▪
Electrical
▪
Mechanical
▪
(800)
426-5480
▪
www.cmafh.com
