1
english
BAM OF-VS-004-__-38
Filter set
Condensed Guide
Installation
Make sure the Identsensor BVS ID is not powered.
Step 1: Remove protection cover
►
Remove protection cover by levering out the cover
using a small screwdriver at the shown spot:
Afterwards, 6 drilling holes for the filter can be seen.
Step 2: Insert O ring
►
Insert the O ring from the filter set and push the o ring
to the edge.
Never insert the filter without the O ring, otherwise it
may become permanently jammed.
About this guide
This manual provides important information for the installa-
tion of the following filter sets into the Identsensor BVS ID:
Order
code
Type
Description
BAM044P
BAM OF-VS-004-
PL-38
Filter for BVS ID, polarization,
38.3 mm, 18 mm, 2 mm
BAM044R BAM OF-VS-004-
RD-38
Filter for BVS ID, red band-
pass, 38.3 mm, 18 mm, 2
mm
BAM044T
BAM OF-VS-004-
IR-38
Filter for BVS ID, IR bandpass
(Daylight Cut), 38.3 mm, 18
mm, 2 mm
BAM044U BAM OF-VS-004-
DL-38
Filter for BVS ID, Daylight (IR
Cut), 38.3mm, 18 mm, 2 mm
Scope of filter set delivery
– AG1 filter Ø38,3/18x2; depending on set
– AG1 filter ring
– 6 countersunk-head screws DIN 965; M2x5 black
– O ring 37x1
Following tools are required for proper installation
– small screwdriver
– countersunk-head screwdriver (M2)
Safety notes
Activities such as
installation
,
connection
and
commis-
sioning
may only be carried out by qualified personnel.
Qualified personnel
are persons whose technical trai-
ning, knowledge and experience as well as knowledge of
the relevant regulations allow them to assess the work
assigned to them, recognize possible hazards and take
appropriate safety measures.
Storing conditions
►
Store product in original packaging.
►
Observe ambient conditions of −25…+85 °C and a
relative humidity of ≤ 80 %.
