Page 7 of 7
(A)
(D)
(B)
(C)
WALL S
TUD
WALL BRACKET MUST BE ATTACHED TO WALL STUD
WALL ANCHORING HARDWARE (ANTI-TIP)
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
Ltr.
A
2
Small Screw
Retention Belt
Qty.
Hardware Included
B
2
Large Screw
C
2
Bracket
D
1
1. Place Desk against wall at desired location then locate and mark a Wall Stud behind unit.
2. Corresponding to Stud location, attach one Bracket (C) into WOOD BANDING on back of Cabinet
using Small Screws (A). If Screw is not driven into wood it may pull out during a tip-over.
*NOTE: Assemble and connect side Cabinets BEFORE installing bracket onto Desk back.
3. To keep hardware out of view after installation, attach remaining Bracket (C)
INTO WALL STUD
with Large Screws (B) 2 inches below Bracket attached to back of unit.
4. Move unit into place, align Brackets then connect both using Retention Belt (D).
5. Confirm Belt is securely laced and locked.
Cleaning & Care
Do not use alcohol based products or spray polisher as finish damage may result.
Periodically dust with a soft, dry cloth.
Anchor Desk into
corner WALL STUD
IMPORTANT
*Be certain connecting
Work Surface Tops
will fit and lay level:
Install Tops
BEFORE
attaching
Coner unit to wall.