Á>UÁ¿É¸¿tµ¿>¸¸¸Á>Ug[¿¿£l½½¤¿lu¼l¼¼¿¿N¿¿ÑÑѦ
L>ggg¦U
¿
5
ASSEMBLY
1
2
Place Dowels
3
in the 2 innermost holes on either
side of the Bottom Shelf
H
.
Insert the Cam Bolts
1
previously installed in the
Left Divider
D
into the corresponding holes in the
edge of the Bottom Shelf as shown. Secure by
inserting a Cam Nut
2
into each of the adjoining
holes in the underside of the Bottom Shelf. (HINT:
the small arrow on the flat side of the Cam Nut
should point toward the adjoining panel.) Use a
Phillips-head screwdriver to turn the Cam Nuts
clockwise to secure the Cam Bolts.
Attach the Right Divider
E
to the Bottom Shelf
using the same method.
Install the Drawer Runners
8
on the Left and Right Dividers
D
/
E
.
Hardware Required:
2
Cam Nut x4
3
Dowel x4
8
9
FRONT
BACK
Fully extend the runner to uncover the
mounting holes. After
attaching
the
runner
to
the panel, push runner back
into the closed position.
9
9
8
9
FRONT
BACK
9
9
FRONT
BACK
1
D
9
8
ASSEMBLY NOTE: Use a Phillips-
head screwdriver to tighten each
Cam Bolt you install until its
threads are fully inserted.
1
E
9
FRONT
BACK
8
Hardware Required:
1
Cam Bolt x4
8
Runner x2
9
Screw (3x12mm) x6
Fully extend one Runner and align the inner section along the 3 small holes on the Left Divider. Verify that the
orientation of the Runner matches the diagram, then fasten the Runner to the Divider using 3 Screws
9
positioned as shown. Once the Runner is attached, slide it back to the closed position.
Attach the second Runner to the Right Divider
E
following the same method, checking orientation before
inserting Screws.
Insert a total of 4 Cam Bolts
1
into the indicated holes above the Runners on each Divider.
→
→
2
H
D
E
3
2
2
3