Vigil 3 Amplifiers
Installation Instructions
10
Vigil 3 Amplifier Installation Manual issue 1
Should the OK/FAULT not be permanently illuminated green
please refer to Table 3.1 for fault finding information
Table 3.1 — Fault Finding
3.2 D
ISASSEMBLY
P
ROCEDURES
There are no Disassembly Procedures for this unit.
OK/FAULT LED Status
Fault
Check
Off
No Power Present (24V or
Mains)
Battery Connection
Battery Voltage
Battery Fuses
Mains Connection
Mains Fuses / Circuit
Breakers
Flashing
24V or Mains Supply Failed
Remove 24V supply if LED
extinguishes then fault is with
mains supply. Check mains
supply as above.
Remove Mains Supply if LED
extinguishes then fault is with
24V supply. Check battery
connections as above.
If both Mains Supply and 24V
supply are present at the
amplifier module then it has
failed and must be returned
for service.
Yellow
Overload or
Overtemperature Fault
Disconnect speaker lines, if
LED returns to Green then
either the speaker lines are
overloaded or shorted
Disconnect speaker lines, if
LED remains yellow then an
overtemperature fault has
occured. Allow amplifier
module to cool and check
cooling fans.
!
W
AR N I NG
The Vigil 3 Amplifiers output stages contain Hot Parts, High
Voltages, and operate at High Frequencies.
Do not attempt to disassemble these units or operate them
without the covers in place.
Summary of Contents for Vigil 3
