3-3
Receiving and Installation
MN715P
Cover Removal
The cover is made of plastic and could be damaged during removal if handled
roughly. Refer to Figure 3-1. Insert a screw driver or small blade tool and pry
the cover outward as shown to release the side.
When both sides are released, remove the cover.
Figure 3-1 Cover Removal
Use small screw driver or
suitable tool to pry cover
slightly outward to release
cover from its catch.
Use small screw driver or
suitable tool to pry cover
slightly outward to release
cover from its catch.
Terminal Identification
The terminals for signal, AC power and motor connections are shown in
Figure 3-2. Separate ground connections are provided for power and
motor grounds.
Figure 3-2 Terminal Identification
J4 Control Terminal Strip
J5 Power Terminal Strip
Power
GND
Motor
GND
L1 L2 L3
T1 T2 T3
B-
R2 R1
1
P1 P2
P3 P4P5
P6
S1 DIP Switch
Potentiometers
P1 - P6
POWER
FAULT
FWD
REV
STOP
0
10
20
30
40 50 60
70
80
90
100
% Speed
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com