Section
3–12
MN1229
Optional Control Signal Wiring
Continued
Control Inputs (Optional)
These control inputs are optional. Their reference (common) is CREF at X3-7
(see Figure 3-3). The voltage range is +12VDC to +29VDC for these inputs.
They may be used by a PLC or other signal source within your application.
1.
Connect the Machine Input 1 (MA
I
1) signal to X3-16.
2.
Connect the Machine Input 2 (MA
I
2) signal to X3-17.
These inputs are galvanically isolated. Their reference (common) is CGND at
X3-8 of Figure 3-3.
3.
Connect the Pulse Input signal to X3-14.
4.
Connect the Direction Input signal to X3-15.
Control Outputs (Optional)
Four Opto Isolated outputs are available for “Active Low” (Sink) use.
Connect one or more of the control outputs as follows: (see in Figure 3-9).
1.
Connect the Ground Return of the power source to X3-8.
2.
Connect a customer pr24VDC source (range = +12VDC to
+29VDC) to X3-6 the CIV input (Customer Input Voltage).
3.
Connect Machine Output 1 (MAO1) X3-18 to PLC.
4.
Connect Machine Output 2 (MAO2) X3-19 to PLC.
5.
Connect the Drive OK load to X3-20.
Figure 3-9 Optional Control Outputs
Machine Output 1
Machine Output 2
Drive OK
6
18
X3
19
20
8
To Customer
Provided PLC
Ground Return
CIV *
* 24VDC nominal at 100mA minimum.
Note:
These outputs are programmable. Refer to software setup manual for
further details.
