16
After Sales Support
1300 663 907
Model Number
KOG6789
Quick Guide
Printing a File
1.
Turn on the 3D Printer, using the switch on the back of the Control Box. Once initiated, press
the Dial to enter the menu system. Navigate to, and select
Position
>
Z Pos. Fast.
Turn the
Dial to the right to raise the Extruder to about 30mm. Press the Dial to return to the previous
menu and select back
2.
Navigate to, and select
Quick Settings
. Navigate to and select
Preheat PLA
. Wait for the 3D
printer to automatically return to the home screen, after approximately 15-30 seconds
3.
Check the temperature of the Extruder and plate on the LCD. When the temperatures are
within a few degrees of the target, you are ready to insert the filament.
NOTE:
Preheat PLA will still be shown, even after temperatures have been
reached. Insert the end of the filament into the hole on the Extruder as shown
4.
While holding the filament in place with one hand, press the Dial
to enter the menu system. Navigate to and select
Extruder
>
Extr.
Position
. Gently push down on the filament while turning the Dial clockwise. You will feel the
filament being pulled into the Extruder. Continue until a few centimetres have extruded out
of the nozzle. Carefully clean the extruded filament off the Heated Print Bed and nozzle using
a cloth taking care not to burn yourself on the hot surfaces
5.
Insert the included MicroSD card into the slot on the side of the Control Box. Press the Dial to
enter the menu system. Navigate to and select
SD Card
>
Mount Card
>
Print File
.
Summary of Contents for KOG6789
