How to install your Reformer with Tower
BEFORE BEGINNING ASSEMBLY
These instructions include a
parts list. Please use this list
to make sure you have all the
parts necessary for installation.
If you are missing a part,
please contact our customer
service department at
1-800-PILATES
(1-800-745-2837).
REQUIRED TOOLS
»
3/16” Allen Wrench (Included. GEN9280)
»
21mm x 1/2 inch wrench (Included. ALL0060)
PARTS FOR TOWER
DESCRIPTION
PART NO.
QTY
Vertical tubes with eyebolts installed
TRP0105
2
Horizontal tube with eyebolts,
safety strap, and corner connectors
TRP0100
1
Push Through Bar for slider assembly
707-287
1
Yellow trap springs
SPR9002
2
Blue trap springs
SPR9004
2
Roll down bar
710-010
1
Yellow long springs
SPR9006
2
Purple long springs
SPR9461
2
Single cotton loops (pair)
101-005
1
Push Through Bar slider assembly
N/A
2
Push Through Bar slider shoulder bolt
619-202
2
1. Loosen the setscrews in the circular tube receivers with
included Allen wrench (see Figure A).
2. Remove the vertical
tower poles from the
box and place them
into the receiver bracket
on the end of the
Reformer. The knobs of
the sliders will be facing
outward as shown in
Figure B.
3. Place the top horizontal
tube onto the two
vertical tubes which go
into the corner brackets.
Make sure when you
place the tubes into the receiver that the loop is facing
forward, towards the carriage, see Figure C.
Figure A: Loosen set-screws here.
Figure B
Knobs
outward
Figure C
Loop should face
the reformer.
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | [email protected]
400-351 | 10.10.16
