How to Install Your Balanced BodY PIlates IQ™ reformer KnoBs
to Protect Parts from damage durIng sHIPPIng, Your IQ reformer comes wItH tHe frame KnoBs detacHed.
Please use tHe followIng InstructIons to reattacH.
Parts you will need:
602-011 6/32 by 3/8” Allen cap screw (2)
201-030 #6 Fender washer, Black (2)
203-001 IQ Reformer knob (2)
See Figure One for part orientation
You will also need:
One 5/64” Allen wrench (included)
On the head end of the stationery frame rails (non-telescoping) there are two silver threaded knob housing units. They look like protruding
bolts. This is where you will attach your IQ knobs. To attach:
1. Place the knob over the protruding housing unit, making sure that the long sides of the knob match up with the die-cut flat edges of the
housing as show in Figure 2.
2. Insert the washer over the open area in the middle of the knob and insert the small Allen cap screw through the washer and into the housing
as shown in Figure 3.
3. Tighten with the Allen wrench, turning clockwise.
4. Repeat on other side.
QUESTIONS? Call 1-800-PILATES x219 for tech support.
IQ Knob
Allen Cap Screw
Black Washer
Knob Housing (already
installed on frame)
Fig. 1
Fig. 2
Long side of IQ Reformer Knob
Flat edges of knob housing
Fig. 3
Housing
Black Washer
Allen Cap Screw
06/06
Open area of knob (washer will
cover in stop 2)
