background image

3

Note: If the bracket does not line up with the inner holes, use 

the outer holes for the eyebolt and the inner holes for the 

flathead. 

10. (Those who have purchased the full Tower system start 

here.) 

Loosen the four set screws in the sockets on the Tower 

bracket so the main tubes can slide through. 

11.  Remove the vertical tower system and place them into the 

receiver bracket on the end of the Reformer. The knobs of the 
sliders will be facing outwards as shown in Figure G. Make 
sure when you place the tubes into the receiver that the loop 
is facing forward, towards the carriage, see Figure H.

12. Now tighten all set screws on the bracket receivers. If PTB 

sliders do not move easily, the vertical tube set screws must 
be loosened and the vertical tubes rotated into alignment. 
Then re-tighten set screws.

13. Your shoulder rests will now be held in place by a detent pin or 

a knob (214-000) for easy removal and installation. Drop the 
screw through the shoulder rest from the top and tighten the 
knob from under the carriage. 

HOW TO ADJUST YOUR SLIDING PUSH THROUGH BAR

Position your hands on the outside of each slider.  Place your 
middle and/or ring fingers under the silver base of the knob; right 
where the black body of the knob threads into.  Place your index 
finger and thumb around the knob itself.  Pull each of the knobs 
outwards, away from the vertical tubes, until they stop.  Using the 
same force on each arm, move the slider upwards or downwards 
to each new location.  Once you near a new location slightly 
release the outward pull of the knobs. The pins will automatically 
fall into the next position when aligned.  

CLEANING AND MAINTENANCE

It is recommended to check to ensure the pins in the plunger 
knobs protrude and lock into the vertical tubes. First pull both 
knobs out and start moving the sliders to a different position.  
Release the knobs before the next hole and continue to slide the 
system. Once over a hole the pin of the knob will drop into the 
opening. Once each slider is in a new position apply a down force 
on the PTB directly downwards. The pins of the sliders should 
not come out of the holes. If the pins do not stay in the tube 
holes, the pull knobs need to be replaced; call Balanced Body for 
replacement parts.

Fig F (only one side shown)

GEN9232

210-050

GEN9305

GEN9021

GEN9305

Fig G

Knobs outward

Strap loops face 
the reformer.

Fig H

Reviews: