IQ® AND SPORT REFORMERS
Attach jumpboard bolt and washer into hole at foot-end of
frame. Then place the footbar in holes closest to foot-end
(see orientation in Figure Q) and lock in place.
The cutout on the bottom of the board will slide over and around
jumpboard bolt with washer against knob. The jumpboard should
now be resting against footbar. Tighten bolt assembly to secure
jumpboard (Figure Q).
ALLEGRO® 2 REFORMER
Before installing the jumpboard, position the footbar in the lowest
position, so that the jumpboard won’t touch the footbar when
installed. Support of the footbar is not required on the Allegro 2.
To use the foot plate, slide the posts into the receivers until the
jumpboard rests on the standing platform (Figure R).
Figure R - The footbar must be in the lowest position and set
closest to the standing platform end of the Reformer.
Correct footbar positioning
STOP!
Incorrect footbar positioning
Figure S - If not in the correct position, the jumpboard could
damage the footbar.
IMPORTANT!
Failure to correctly position the footbar
when installing the jumpboard could damage the foam on
the footbar. This damage is NOT covered under warranty.
Figure Q
Contact Us
1-800-PILATES | +1-916-388-2838
pilates.com | [email protected]
400-017 | 09.27.19
