ALLEGRO® REFORMER—JUMPUS MAXIMUS
To install the Jumpus Maximus on your Allegro or Allegro Stretch,
set up the trunnions based upon which model of Allegro you
have:
1. Slide footbar to last position (from carriage) and lock.
2. Adjust footbar on trunnion depending on your model.
For Allegro: Move footbar to top position (Figure L).
For Allegro Stretch: Move footbar to second from top position
(Figure N).
3. Insert jumpboard inside of footbar. Bottom clip of padded
jumpboard fits into slot on reformer (Figure G).
When installed correctly the padded jumpboard will be supported
by the footbar (Figure M).
If there is a gap between the jumpboard and the footbar, a grey
strip of foam is included that can be installed on the back of the
jumpboard to fill the space.
RIALTO® REFORMER
Before installing the jumpboard, position the footbar in the lowest
position, so that the jumpboard won’t touch the footbar when
installed. Support of the footbar is not required on the Rialto.To
use the jumpboard, slide the posts into the receivers until the
jumpboard comes to a stop. (Figure N).
Figure N - The footbar must be in the lowest position and set
closest to the standing platform end of the Reformer.
Correct footbar positioning
Figure M - Allegro Stretch
Figure L - Allegro
1
1
2
2
STOP!
Incorrect footbar positioning
Figure P - If not in the correct position, the jumpboard could
damage the footbar.
Figure N
3
