Balanced Body Allegro Reformer, Manual

Page: 17 / 49

15
1. Install the legs onto the foot end of the frame in the same
way with the 6 screws. No leg nut plates are required at the
foot end.
2. Using a 7/16” wrench and the included allen wrench, install
the transport wheel brackets with the 1/4-20 screws and nuts
as shown in Figure G. Make sure the brackets are oriented
as shown. Typically these are installed at the foot end of the
Reformer as shown in Figure G.
NOTE
: The transport wheels can also be installed at the head
end which allows you to move the Reformer with Tower more
easily. Just make sure the carriage is rolled to the head end
of the Reformer before lifting the foot end of the machine in
this configuration.
3. Using two 1/2” or adjustable wrenches, remove the transport
wheels from their current location and install them onto
the brackets you just installed. Leave the old transport
wheel brackets in place, as that is where a footstrap can be
attached. See Figure H.
NOTE
: It is critical that the washers and wheel get installed in
the same order and orientation as they were on the original
brackets. Do one wheel at a time and if the wheel does not
spin freely after you are done, double check against the other
wheel to make sure everything is in the right order.
4. Re-install the head end rail cover plates on the same side you
removed them from.
NOTE
: If you will be installing a Tower System next, leave the
head end rail cover plates off.
5. Your legs are installed and you may now carefully lift and turn
your Allegro Reformer back over onto the legs. Re-install your
shoulder rests, risers, and ropes.
Figure H
Do not forget this
washer between the
wheel and bracket.
Leave this
bracket here.
Figure G (Footbar not shown)