Balanced Body Allegro Reformer, Manual

Page: 15 / 49

13
How to Install the Allegro
®
Legs Kit
PARTS INCLUDED:
Item No. Part Number Description Qty
1 618-030 Allegro Leg, A 2
2 618-031 Allegro Leg, B 2
3 618-021 Leg Nut Plate 2
4 614-020 Wheel Bracket, Allegro Ext
Leg 2
5 GEN8320 Allen Key, 3/16” Ball Point 1
6 GEN7321 Screw, Button Head, 5/16-18
x 3/4” 12
7 GEN7325 Screw, 1/4-20 x 3/4” 4
8 GEN9021 Nut, Nylock, 1/4-20 4
9 GEN9282 Allen Key 5/32” Short Arm 1
10 618-135 Polyurethane Foot Pads 4
11 GEN9600 Double Sided Tape 4
12 GEN6742 Flat Head Screw 10-24 x
5/8” 4
13 GEN9856 #10 Flat Washer 4
14 GEN9059 #10 Nylon Nut 4
15 GEN9284 1/8” Allen Wrench 1
16 FAK1000 Alcohol Wipe 4
TOOLS NEEDED (NOT INCLUDED):
» Two 1/2” or adjustable wrenches
» One 7/16” wrench
» 3/8” wrench or socket
PREPARE THE NEW PADS
1. Remove the legs and other materials from the packaging and
lay the legs on the floor with the bottom of the leg facing up,
so the “L” shape face with three holes are on the floor
2. Remove the (4) Polyurethane foot pads, and (1) Alcohol wipe
from the packaging. Open one wipe and thoroughly wipe
down the top side of each foot pad. This is the side opposite
the ribbing. If the wipe is dirty or becomes too dry use another
wipe for the remaining pads. Set the pads aside and let these
dry.
3. Open an Alcohol wipe to clean the bottom of each metal foot
on the reformer. If needed use a secondary wipe.
4. If you have a Tower Of Power installed, remove the ropes,
loosen the 4 tower knobs, and remove the tower.
5. Using the included shorter allen wrench, remove the 4 screws
holding the head end cover plates and riser pins in place. Set
them aside to be re-installed later. See Figure A.
1
2
10
3
5
4
9
7
6
8
Figure A
13
16
11
15
14
12