Operating the VK-6200
Turning the VK-6200 On:
The power switch is located in the center of the front panel of the VK-6200. Pressing on the
top of switch bar will turn the unit ON and OFF, provided the VK-6200 is not in its Standby
mode (see below for operation in Standby mode).
Front Panel Indicators:
There are three LED indicators on the front panel of the VK-6200:
1. Blue Power ON indicator
2. Green STANDBY indicator.
3. Red FAULT indicator
Their operation is described below:
Blue Power On indicator:
It comes ON when the unit is powered up. Pressing the power switch will make the unit
alternate between its ON and OFF state, provided it is not in its STANDBY mode.
NOTE: Your VK-6200 is equipped with a smart power ON management circuit. This
circuit applies power only to those channels that are installed. It does so in sequence,
minimizing the initial power surge in order not to stress your power line. When turning the
VK-6200 ON you will hear several relay clicks inside the unit. The number of clicks will be
equal to the number of channels installed in the chassis.
When additional channels are installed in the VK-6200 chassis, the circuit will
automatically recognize them and power them up in proper sequence.
Summary of Contents for VK-6200
Page 9: ......
