Baker M6 DeDuster - Rev 1, 11/07
;
WWW.BAKER-ONLINE.COM
19
MAINTENANCE
General Clean Up
Note: Follow proper Lockout / Tagout procedures prior to cleaning or performing
maintenance on any part of the machine.
On a daily basis use an air-hose to blow-off the dust and wood chips that accumulate in,
on and around the machine.
The machine operator or clean-up person is closer to dangerous operating mechanisms
of the machine during clean up than during production – extra care should be taken
during this time.
Do NOT clean with flammable or combustible materials.
Follow applicable codes and standards with regards to:
Ventilation and monitoring of work area for excessive accumulation of hazardous
vapors
Wearing personal protective equipment for handling materials
Using proper procedure for disposing of all waste materials
Inspection and Preventative Maintenance Checklist
Frequency
Recommendation
Daily
(Approx. 8 hrs)
Complete a visual inspection of the machine before the beginning of each
production day and look for loose, worn, broken or defective parts.
Weekly
(Approx. 40 hrs)
Check the conveyor belt for cracks and ensure tension is “taut” with no more than
1/2” of deflection in the belt.
Weekly
Check the material transportation chains and ensure tension is “taut” with no more
than a 1/2” of play in the tension of the chains.
Weekly
Grease the material pusher linear rail bearings. We recommend JT-6 grease (
no
more than 3 pumps
).
Every 3 Months
(Approx 480 hrs)
Grease bearings using high temperature grease. We recommend JT-6 grease (
no
more than 5 pumps
).
Important Notice:
Improper lubrication
will void warranty.
