Baker Band Resaw - Rev 1, 09/08;
WWW.BAKER-ONLINE.COM
23
OPTIONAL EQUIPMENT
Simple Slide Return Options
If you did not order a return conveyor but wish to add it now, simply call and order it, then
follow these directions for installing it:
Drain the fluid from the
Baker B/BX
into a clean reservoir so it can be reused.
Position the Return Conveyor and thread the supplied bolts into the side of the conveyor
and through the holes on the side of the
Baker B/BX
. Put the nuts on the exposed end of
the bolts and tighten.
Connect the hydraulic motor to the Feedworks Start/Stop Assembly with the supplied
hoses.
Tie up the hoses so that they are out of the way.
Refill the tank with hydraulic fluid.
Run the saw.
BLADES
The standard
Baker B
uses the following blades:
13’ – 2” x 1” x .035 2T Woodmaster C Band Blades
The standard
Baker BX
uses the following blades:
14’ – 2” x 1” x .035 2T Woodmaster C Band Blades
14’ – 2” x 1” x .035 also available
NOTE:
1-1/4” guide plates as well as other blade widths, thickness and tooth spacing are
available upon request.
Ask your sales consultant or the customer service department for details.
Blade usage is approximately two blades per day per head during full production. Use this
figure when ordering your blades until you have developed some record of blade usage for
your operation.
Using high quality blades is an important factor in achieving the highest performance out of
your
Baker B/BX band resaw
. Our machines are tested and set-up using
Lenox
blades
sold by
Ellington Industrial Supply
. These are very good blades for use on the Baker and
come highly recommended by the majority of Baker owners. If you would like more
information on these blades, contact:
Customer Service Department
Ellington Industrial Supply Co., Inc.
PO Box 128
Ellington, MO 63638 USA
Tel: (573) 663-7711
Fax: (573) 663-2787