Baker Hughes Panametrics oxy.IQ, User Manual

Page: 21 / 56

oxy.IQ User’s Manual 13
Chapter 4. User Programming
Chapter 4. User Programming
4.1 Introduction
IMPORTANT: The oxy.IQ service menu is for use by qualified service personnel only and requires a special passcode
for access. That menu is not discussed in this chapter.
This chapter provides instructions for programming all of the oxy.IQ menu options available to the user, which can be
accessed without the use of a passcode. These menu options are found in the following main menu submenus:
• Calibration menu
• Display menu
• Output menu
• While programming these menus, refer to the menu map in figure 16.
Note: The menu options for initial setup are described in chapter 3, Initial setup and operation, and are only
referenced in this chapter.
4.2 The Calibration Menu
Proceed to the appropriate section to program the desired menu option.
4.2.1 Air
See “Air Calibration” on page 11 .
4.2.2 Span Gas
See “Span Gas Calibration” on page 12 .
4.2.3 Sensor Life
To read the sensor life, complete the following steps:
1. Press the Enter key to enter the Main Menu .
2. Press the Enter key to enter the Calibration menu.
3. Press the key three times and then press the Enter key to enter the Sensor Life menu.
4. The number of days your sensor has been in use is displayed. When you have finished reading the information,
press the
Enter key to return to the Calibration menu.
5. Press the Cancel key twice to return to measurement mode.