15
Max
Max
R
GAS HOT PLATE
1. Open the manual gas supply valve (which will release gas into the equipment).
2. Light the burner pilot until the flame ignites, repeat on all others. (see image below).
Note: The ignition order does not interfere with the use of the equipment.
3. Turn the knob corresponding to the burner you wish to operate counterclockwise
(adjust the flame through the knob).
4. Make sure the burner is lit. If the burner does not light, repeat the procedure.
Note: The pilot burner flame is factory set according to the gas for which the equipment
was originally manufactured. Always check that the pilot burner flame is lit. If it is not,
perform the procedures described above again.
DETAIL A
SCALE 2:5
NOTE:
If you need to adjust the pilot valves (one pilot valve corresponds to two burners) do
the following:
1-Turn the pilot adjusting screw counterclockwise, then light the pilot with the aid of the
igniter (wick) accompanying the equipment and adjust the flame to a height of
approximately 13/64" (0.5 cm);
2- Turn on the gas valve by turning the knob counterclockwise to light the main burners;
3- To shut down completely, close the gas valves by turning the knob clockwise and turn
the pilot adjusting screw clockwise to close the gas for the pilots.
Pilot screw adjustment
More gas
Less gas
