Baja sportub series, Owner'S Manual

Page: 11 / 20

SPORTUB II 1057-58 Controller Operations
JET1 - The JET1 button is used to turn the pump on or off at selected speeds. The first press will
turn the pump to LOW speed. The second press will change the pump to HIGH speed. The third
press will turn the pump off or return to a heat or filtration mode (see note). A built in timer will shut
the pump off 20 minutes after it has been started unless the user does so manually. When the
pump is on, the "Jets On" indicator will appear above the JET1 button.
Note: You may not be able to turn the pump off if it has started a filtration cycle or if the spa is calling for additional
heating. This is easily identified by observing the status of the "Heater On" indicator light or the "Filter Cycle" indicator
light.
JET2 - The JET2 button is used to turn the JET2 booster pump on or off. The first press of the
JET2 button will start the booster pump. A second press will turn the booster pump off. The JET2
booster pump will automatically turn itself off after 20 minutes. When the JET2 booster pump is
on, the JET2 indicator light will appear above the JET2 button.
LIGHT - The LIGHT button is used to turn the light on or off. The first press of the LIGHT button
will turn the light on. The second press of the button will turn the light off. The light will
automatically turn itself off after 2 hours. When the light is on, the indicator light will appear above
the LIGHT button.
TEMPERATURE PROGRAM - The temperature program button is used to set the desired water
temperature. Press and hold this button to increase or decrease the desired temperature setting.
Release and press again to increase/decrease to the desired temperature setting. The
temperature can be adjusted in 1°F increments from 59°F to 104°F (or 15°C to 40°C). The desired
temperature setting will remain in the display box for 5 seconds as confirmation of the new setting.
After 5 seconds, the display will show the current water temperature.
Note: The temperature program indicator will appear to indicate that the temperature in the display is the desired
programmed temperature and not the actual water temperature.
Note: A power outage to the system will erase any programmed settings. If a power outage
should occur, it will then be necessary to re-program the system. Filtering default is 120
minutes, twice a day. Temperature default is 100 degrees.
10
Programming Number of Filter Cycles:
You may choose to filter the spa 1, 2 or 3 times daily as required to maintain clean water. To view
the current number of filter cycles,
press & hold the Pump1 button for 5 seconds.
The current number of filtration cycles will be displayed. This setting can be modified by holding
down the Up/Down button until the desired number of cycles is shown. A simultaneous
press &
hold of the Pump1 & Up/Down button for an extra 5 seconds will start a new filter cycle.
Programming Cycle Duration
You may choose to filter spa 60, 120, 180 or 480 minutes per cycle as needed to maintain filtered
water. To view the current length of each filter cycle, press & hold the Light button for 5 seconds.
The current length of each filtration cycle will then be shown.
This setting can be modified by holding the Up/Down button until the length of each cycle is shown.
A simultaneous
press & hold of the Pump1 & Light button for 5 seconds more will start a new filter
cycle.