CHANGING THE OIL, CLEANING OIL FILTER SCREEN
1. Remove the oil drain plug, spring and oil filter screen located at the bottom
of the engine and let the oil drain into an approved collection container.
DO NOT PERFORM THIS PROCEDURE WHILE THE ENGINE IS HOT.
SERIOUS BURNS COULD RESULT FROM CONTACT WITH HOT OIL.
2. Dispose of the used oil properly. For proper disposal procedures, contact
your local oil recycling center
3. Clean oil screen and spring with solvent
4. Clean and replace the oil drain plug making sure it is secure.
5. Refill the engine with the proper amount of oil and recheck the amount of
oil in the engine by using the oil gauge plug and/or sight gauge.
CHECk-UP OF SPARk PLUG
1. Remove the cap of spark plug and screw off
the spark plug using the plug wrench.
2. Clean the spark plug all around or replace it
if it is corroded or there is too much deposit
on it.
3. Regulate the gap of the spark plug to 0.6-
0.8mm. (.024 inches - .032 inches)
The spark plug of the designated type
should be used. The applicable type of
spark plug: D8EA (NGk)
0.6~0.8mm
(.024 inches -
.032 inches)
Oil drain plug
Oil filter screen
Spring
Summary of Contents for DR125
Page 33: ...30 DR125 wire diagram...
