5
6. Once the bracket sits flat on the lower hinge face and is aligned with the hinge mounting
holes, replace the two 13mm bolts and tighten. Lightly press the plastic cowling back into its
clip fasteners.
7. Repeat steps 2-6 for the opposite side of the vehicle.
8. The light assemblies may now be bolted to the top of each bracket using both the
9/16”
wrench and 9/16” socket.
Wiring Guide
1.
Use the provided harness and connect both A-Pillar lights.
2.
Determine a desired dash location for the toggle switch. Using a ¾” stepped drill bit, drill a
hole. Be mindful of what is behind the dash and remove dash if necessary.
3. Take a quick picture of the switch terminals for reference later. Remove the switch
terminals from the switch, run the harness through the firewall and through the desired
dash location. Reattach the toggle switch and press into the dash.
4. Connect the +12V (red wire) to the positive battery terminal and the -12V ground (black
wire) to the negative battery terminal.
Re-torque all the fasteners after 100 miles.
Your install is now complete! Thank you for choosing Baja Designs.