8
STANDBY
GETTING STARTED - INITIAL SET UP
1) Connect the TV to the TV Aerial wall socket
(Fig A)
2) Connect the power cable to the Mains Adaptor
and the Mains Plug to the wall socket. Ensuring the
wall socket is OFF, connect the DC Output of the
Adaptor to the TV “DC IN” connector.(Fig B)
3) Insert the batteries into the Remote control. Take
care to observe correct polarity.
4) Switch on the television using the red (power)
button on the remote control: or on the top of your
TV.
Fig A
Fig B
Getting Started - Initial Set Up
5. You will now be welcomed with the initial set-up
screen. Press OK to confi rm OSD LANGUAGE. Then
press OK again and the auto tuning will start.
6) After tuning the following screen will appear.
Press OK to confi rm Country Code, again to
confi rm Primary region and twice more to confi rm
Secondary and Tertiary Regions. Your fi rst
Programme should now appear.
Tip: If the TV fi nds some, but not all, of the Digital channels, the TV is functioning correctly but the signal being
received is not strong enough. (The signal strength needs to be above 85% - you can see the signal strength
the TV is receiving when you change channels/ programmes) you will need to increase the signal reception
in order to receive all of the channels available. The most economical way to do this is by purchasing and
connecting a ‘signal booster’ in between the TV and the TV aerial socket. If this does not solve the problem,
you will need to upgrade the TV aerial to a digital hi-gain compatible aerial
Signal Booster
Conne
c
t between TV
and TV aerial so
ck
et
