Bailey NIAO01, Instruction

Page: 24 / 27

INTRODUCTION
I-E96-438A A - 1
APPENDIX A - IMAOM01 ANALOG OUTPUT MODULE
INTRODUCTION
The IMAOM01 Analog Output Module produces eight analog
output signals in response to messages received over the mod-
ule bus from other modules in the system.
Figure A-1 shows the dipswitch and jumper locations on the
AOM module. Determine the address for the AOM module and
set S2 dipswitches to the corresponding address positions.
Table
A-1 shows example address switch settings.
Jumper E3 selects either standard outputs (individual one to
five VDC or four to 20 milliamps) or zero to ten VDC for all eight
outputs. Table
A-2 shows how to set the jumpers on the AOM
module.
When jumper E3 is set for standard outputs, jumpers E6 (AO8)
through E13 (AO1) set analog outputs one through eight for
either four to 20 milliamps or one to five VDC.
NOTE: Do not move jumpers E1 and E2. They are factory installed.
Figure A-1. Analog Output Module Layout
MODULE STATUS LED ADDRESS SWITCH
MODULE RESET
SWITCH
OUTPUT VOLTAGE
RANGE JUMPER
OUTPUT MODE
JUMPERS
T00717A
1 5
OPEN
S2
P1
P3
P2
EDGE
CONNECTORS
E2
1
2
3
E6
1 2 3
E7
1 2 3
E12
1 2 3
E11
1 2 3
E10
1 2 3
E9
1 2 3
E8
1 2 3
E13
1 2 3
E3
1
2
3
E1
1
2
3