Bailey Infi 90 NTAO01, Instruction

Page: 25 / 28

INTRODUCTION
I-E96-407A A - 1
APPENDIX A - IMAOM01 ANALOG OUTPUT MODULE
INTRODUCTION
The IMAOM01 Analog Output Module produces eight analog
output signals in response to messages received over the mod-
ule bus from other modules in the system. For more informa-
tion, reference the IMAOM01 Analog Output Module product
instruction.
Figure A-1 shows the dipswitch and jumper locations on the
module. Determine the address for the module and set S2
dipswitches to the corresponding address positions shown in
Table
A-1 .
Jumper E3 selects either individual one to five VDC or four to
20 milliamps, or zero to ten VDC for all eight outputs. When
jumper E3 is configured for zero to ten VDC, all outputs must
be configured for voltage outputs. Table
A-2 shows how to set
the E3 jumper on the module.
When jumper E3 is set for one to five VDC, jumpers E6 (AO8)
through E13 (AO1) set analog outputs one through eight for
either four to 20 milliamps or one to five VDC. Table
A-3 shows
the settings for jumpers E6 through E13.
NOTE: Do not move jumpers E1 and E2. They are factory
installed.
Figure A-1. Analog Output Module Layout
MODULE STATUS LED ADDRESS SWITCH
MODULE RESET
SWITCH
OUTPUT VOLTAGE
RANGE JUMPER
OUTPUT MODE
JUMPERS
T00507A
1 5
OPEN
S2
P1
P3
P2
EDGE
CONNECTORS
E2
1
2
3
E6
1 2 3
E7
1 2 3
E12
1 2 3
E11
1 2 3
E10
1 2 3
E9
1 2 3
E8
1 2 3
E13
1 2 3
E3
1
2
3
E1
1
2
3