INTRODUCTION
WBPEEUI240759A0
B - 1
APPENDIX B - TRICONEX SYSTEMS PLC
INTRODUCTION
This appendix provides IMEDI01 module information neces-
sary to interface to a Triconex Systems Tricon V6 PLC and
higher (with Network Communications Module). Specifically, it
describes the label information that identifies that the EDI
module contains the Triconex Systems interface protocol. And
it describes function code outputs and specifications. Refer to
for function code descriptions.
NOTES:
1.
This appendix assumes familiarity with Triconex Systems con-
trollers. It may be necessary to refer to Triconex Systems documen-
tation for additional information when defining function code
specifications.
2.
Make sure that the Ethernet connection is to the NET2 port of
the NCM module.
PROTOCOL IDENTIFICATION
A label should be affixed to the EDI module that identifies the
interface protocol contained in the module. Additionally, the
IMEDI01 utilities can be run to view the current interface pro-
tocol (i.e., firmware/protocol) installed. Refer to
in Section 6 for the procedures to run the utilities.
The Triconex Systems interface protocol will be identified as:
TRI 1.00 (or higher)
