INTRODUCTION
I-E96-216A
3 - 1
SECTION 3 - INSTALLATION
INTRODUCTION
This section explains what you must do before you put the
Configuration Port Module (IMCPM01) into operation.
DO NOT
PROCEED
with operation until you read, understand and do
the steps in the order in which they appear. Refer to the Con-
figuration and Tuning Terminal Product Instruction Manual
for more details about the CTT.
UNPACKING AND HANDLING
Special Handling
The CPM does not use electrostatic sensitive devices. No spe-
cial handling is required.
General Handling
1. Examine the hardware when you receive it to verify that it
has not been damaged in transit.
2. Notify the nearest Bailey Controls Sales Office of any ship-
ping or handling damage.
3. File a claim for any damage with the company that handled
the shipment.
4. Use the original packing and container to store the hard-
ware.
5. Store the hardware in clean air that is free from tempera-
ture and moisture extremes.
SETUP AND INSTALLATION
Before installing, check to see that the fuse on the board is
good. There are no jumpers or switches to set on the CPM.
Physical Installation
The CPM module inserts into a standard INFI 90 Module
Mounting Unit (MMU) and occupies one slot. To install:
1. Align the module with the guide rails in the MMU. Gently
slide the module in until the front panel is flush with the top
and bottom of the MMU frame.
