44
44
LUBRICATION AND MAINTENANCE
Daily Maintenance
•
Check daily for any unsafe conditions and fix immediately.
•
Check that all nuts and bolts are properly tightened.
•
Do a general cleaning by removing dust and scrap from the T-slots on the bed. Keep area
around machine clear of debris.
•
Check that the control console circulating fans are working and the emergency stop button is
in good working order.
•
Clean the machine and lubricate unpainted surfaces with a Teflon lubricant. Wipe off any
excess and buff with a dry polishing cloth. This will reduce the chance of rust forming.
•
Check cutter teeth for chips and dullness. Sharpen or replace any worn or damaged tooling.
•
Generally inspect the machine for damage and loose or worn parts.
•
Collets & spindle collet hole must be cleaned regularly.
•
Ensure that the slots in the collets are free of sawdust. As sawdust
builds up it will stop the collet from compressing. If the collet or spindle
hole is not clean, the router bit may not run true and this will affect the
performance of your machine.
•
Check the filters on the inlet of the vacuum pump for debris.
•
Inspect the power plug and cord.
Note:
When cleaning chips and debris from the machine, use a brush and a shop
vacuum.
DO NOT
blow off the machine with compressed air. The force of the compressed air
may force chips into critical mechanisms or may inflict injury to yourself or others.
Weekly Maintenance
•
Thoroughly clean the machine.
•
Check any exposed electrical wiring for wear or damage.
•
Inspect the power unit ground clamp for wear or damage.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.
Summary of Contents for WR-105V-ATC
