Baileigh WL-1220VS, Operator'S Manual

Page: 26 / 52

23
23
ADJUSTING TAILSTOCK
The tailstock is equipped with a cam-action clamping
system to secure it to the lathe bed. When the lever is
engaged, a locking plate lifts and secures the tailstock
to the bed.
1. Verify the ON/OFF switch is
OFF and the Lockout
Key is REMOVED .
2. Loosen the release lever (A) and move the tailstock
to the desired position.
3. Tighten the release lever.

If the release lever will not lock or release the
tailstock (either too loose or too tight), loosen or
tighten the tailstock mounting nut (B) located on
the underside of the tailstock in small
increments as needed to achieve the proper
clamping pressure.
ADJUSTING TOOL REST
The tool rest base is equipped with a cam-action
clamping system to secure it to the lathe bed. When
the lever is engaged, a locking plate lifts up and
secures the tool rest base to the bed.
1. Verify the ON/OFF switch is
OFF and the Lockout
Key is REMOVED .
2. Loosen the release lever (C) and slide the tool rest
base along the bed.
3. Tighten the release lever to lock the tool rest base
in place.

If the release lever will not lock or release (either
too loose or too tight), then loosen or tighten the
tool rest base mounting nut (B) located on the
underside of the tool rest base in small
increments as needed to achieve the proper
clamping pressure.
4. Loosen the lock handle (D) and adjust the tool rest
vertically and/or swivel it as needed, then tighten
the lock handle.
Fig 16
C
D
B
Fig 15
Fig 14
A