26
26
CROSSCUT TABLE ASSEMBLY
Lubricate the pivot pin (A) with light grease and
place the stand end of the crosscut table onto the
pivot pin.
Lift and hold the lock handle (B) so that it is pointing
straight up.
Place the slide end of the crosscut table on the on
the slide rod (C) of the sliding table. Verify that the
locking bar of the crosscut table is positioned under
the slide rod.
Tighten the handle (B) to fasten the crosscut table.
Place the two C-shaped aluminum channels across
the crosscut table.
Loosen the bolts on the 2 bar clamps (D) and center
the shorter aluminum channel (E) on the crosscut table
with the bar clamp positioned to clamp the channel in
place.
Tighten the bar clamp bolts (D) to secure the channel.
The longer channel (F) is a movable channel. Loosen
the hand bolt enough to allow the channel to slide over
the plate clamp (G).
Slide the channel over the plate clamp at least 1” and hand tighten the bolt to secure the
channel in place. This channel may be repositioned as needed to support the work material
as needed.
Using a soft mallet, install the end caps into the channels.
Place a straight edge across the crosscut table channels and onto the sliding table to check
if the surface is flat.
Adjust the pivot pin (A) nuts as needed to level the crosscut table to the sliding table.
D
G
E
F
A
B
C
