Baileigh SS-3528, Operator'S Manual

Page: 30 / 52

27
27
Large circular and arc-sha
ped stock can be shaped as described under “CONTOUR EDGE
SHAPING”; however, small sized stock requires the use of special shaping jigs similar to those
shown in Figure 24 and 25.
With the entire fence assembly removed, carefully position the jig for desired depth of cut and
securely clamp to the table.
It is important with the arc and circle shapes that the workpiece, prior to being shaped, must be
roughly cut to the desired size and curve of the finished piece. Make sure the jig curve of the
exactly the workpiece curve. At all times keep the cutter is cutting the stock.
NEVER PERFORM THIS TYPE OPERATION WITHOUT A RING GUARD OR SIMILAR
SAFETY DEVICE OVER THE CUTTERHEAD.