19
19
ADJUSTMENT TRANSMITTING ROLLER
Verify that roller and table are both at the same height.
(Fig. 14)
ADJUSTING TABLE ROLLER
To reduce friction between stock and table, two table roller have been assembled on machine.
Adjustments will be needed when planning with the different types of wood.
Roller must be adjusted high, when planning rough wood.
Roll must be adjusted low, when planning smooth wood.
ADJUST ROLLER
UNPLUG OR DISCONNECT PLANER FROM
POWER SOURCE AND LOCK OUT POWER.
Place a straight level on table roll, loosen screw (A)
adjust your shaft (B) to the proper height and tighten
back the screw to hold in position. (Fig. 15)
Always check to make sure that the front and back
height are the same. There must be no slant between
roller and table.
Fig. 14
Fig. 15
Summary of Contents for IP-208
