20
20
Attach the feed handle to the head assembly.
•
Insert the threaded end of the feed handle (
L
) into the gear oil
fill hole (
J
).
•
Turn the handle clockwise (
cw
) until tight so that the trigger
switch (
K
) points up.
•
Tighten jam nut clockwise (
cw
).
Connect feed handle cable to motor box.
•
Locate the open socket (
M
) at the side of the electrical box
on the motor.
•
Plug the feed handle cable connector into socket (
M
).
•
Use a wrench to tighten the connector nut (
N
).
Attach the support roller to the left side of the base.
•
Place the support roller (
P
) up to the machine base and align
the 2 slots (
O
) with the screw holes in the base.
•
Using (2) M10 washers and (2) M10x25 hex bolts, attach the
support roller to the base.
•
(
DO NOT
Tighten).
•
Place a level across the mouth of the vise and the top of the
roller. Raise or lower roller (
P
) until level, then secure by
tightening bolts.
Attach the bar stop to the vise.
•
Insert the threaded end of the long rod (
R
) into the side of the
vise.
•
Turn clockwise (
cw
) until snug making sure graduated scale
can be easily read.
•
Using a wrench, turn hex jam nut (
Q
) clockwise (
cw
) until
tight.
Attach the cover plate to machine stand.
•
Place plate (
S
) next to the hole at the base of the
machine stand.
•
Align the mounting holes and secure with (4) M5x6
screws.
M
N
O
P
S
Q
R
