Baileigh Industrial B8870, Operator'S Manual

Page: 17 / 32

15
15
Staggered Stop Pattern
With this pattern, the track alternates randomly
between three different sets of lines.
Note : Marking the workpiece with a non-
permanent marker so you can see the outside, middle
and inside lines more clearly. Clean the wheels and
workpiece when you are finished.
1. From the starting point, roll the workpiece from the
outside line on one side to the outside line on the
opposite side.
2. Roll the workpiece from the middle line on one side
to the middle line on the opposite side.
3. Roll the workpiece from the inside line on one side
to the inside line on the opposite side.
4. Repeat Steps 1-3, as you move across the
workpiece, randomly alternating between outside,
middle, and inside lines.
Crisscrossing Tracks
Crisscrossing tracks can help produce smoother curves
in your workpiece using the zigzag or staggered stop
pattern.
After running tracks along one length of the workpiece,
turn the metal sheet 90° and run tracks along the
opposite length so the workpiece is equally covered by
both sets of tracks.